Stihl FS 560 C Manual De Instrucciones página 15

WARNING
To reduce the risk of serious injury,
never use wire or metal-reinforced line
or other material in place of the nylon
cutting lines. Pieces of wire could break
off and be thrown at high speed toward
the operator or bystanders.
STIHL AutoCut mowing head
Nylon cutting line advances
automatically when tapped against the
ground (TapAction).
STIHL TrimCut mowing head
Frayed line is replaced by a simple
adjustment (see instruction sheet
supplied with mowing head).
STIHL DuroCut mowing head
Uses only nylon lines.
Observe wear indicators.
NOTICE
There are four wear limit indicators
shaped like exclamation marks in the
base of the DuroCut. If one of these
built-in indicators becomes visible, do
not continue using the DuroCut since it
might otherwise be damaged. Replace
the worn base plate with a new base
FS 510 C, FS 560 C
plate. It is important to follow the
maintenance instructions supplied with
the head.
STIHL PolyCut mowing head
Uses either nylon lines or nonrigid,
pivoting polymer blades.
Observe wear indicators.
WARNING
Three rectangular wear limit marks are
applied to the base (periphery) of the
PolyCut. To reduce the risk of serious
injury from breakage of the head or
blades, the PolyCut must not be used
when it has worn as far as one of these
marks. It is important to follow the
maintenance instructions supplied with
the head.
WARNING
If the wear limit marks are ignored, there
is a risk of the cutting attachment
shattering and flying parts injuring the
operator or bystanders. To reduce the
risk of accidents from shattered blades,
avoid contact with stones, metal and
similar solid objects. Check PolyCut
blades for cracks at regular intervals. If a
crack is found on one blade, always
replace all blades.
Risk of Kickout (Blade Thrust) with all
Rigid Cutting Blades
WARNING
Kickout (blade thrust) is
the sudden and uncon-
trolled motion towards
the operator's right or
rear that can occur when
the shaded area (espe-
cially the darkly shaded
area) of a rotating blade
comes in contact with a
solid rigid object like a
tree, rock, bush or wall.
The rapid counterclock-
wise rotation of the blade
may be stopped or
slowed, and the cutting
attachment may be
thrown to the right or to
the rear.
This kickout (blade thrust) may cause
loss of control of the power tool and may
result in serious or fatal injury to the
operator or bystanders. To reduce the
risk of injury, extreme caution should be
used when cutting with the shaded area
of any rigid blade.
English
13