Publicidad
Idiomas disponibles
Idiomas disponibles
4
3
3
Handlebar for machines used
mainly for sawing, but also for
mowing and brushcutting.
The machine is supplied with the clamp
moldings (4) mounted on the handlebars
(2, 3).
Do not change the position of the
N
clamp moldings on the handlebar
until it is mounted on the handle
support.
The mounting procedure is the same for
both types of handlebar. Therefore, the
following description only shows
handlebar (2).
Mounting the Handlebar
Assembly of the swivelling handle
support involves equipping the clamp
moldings with a spring and mounting
them on the handle support.
FS 510 C, FS 560 C
5
Use the spring (5) from the parts kit
N
supplied with the machine.
Push the spring (5) into the lower
N
clamp molding (6).
4
7
Position the clamp moldings (4) with
N
handlebar (2) on the handle support
(7).
Do notturn the handlebar in the
N
clamp moldings.
Raise the grip of the wing screw (8)
N
to the upright position.
Rotate the wing screw
N
counterclockwise and tighten it only
moderately.
8
2
Position wing screw (8) in threaded
N
insert in handle support (7) – against
pressure of spring (5).
Position the clamp moldings so that
N
the tabs (9) on the lower clamp
molding (6) line up with the slots
(10) in the handle support (7).
English
8
5
7
6
9
7
10
19
Publicidad
