Publicidad
Idiomas disponibles
Idiomas disponibles
English
4
Fit the other two retainers (4) on the
N
gearbox and tighten down the
screws only moderately.
Align the grass shield so that the
N
center of the front retainer is in line
with the rib on the gearbox.
Tighten down the screws firmly.
N
5
1
Fit the 2.4-in (60-mm) diameter
N
thrust plate (5) on the shaft (1).
NOTICE
Only use the 2.4-in (60-mm) diameter
thrust plate. The 2.6-in (65-mm)
diameter thrust plate is too big and must
24
not be used – see chapter "Mounting the
Cutting Attachment / Mowing Head /
Grass Cutting Blades".
6
1
Place the guard washer (6) on the
N
thrust washer – the whole collar
(arrows) on the shaft (1) must be
visible.
Mounting the Cutting
Attachment
Placing power tool on the ground
Shut off the engine.
N
Lay your power tool on its back so
N
that the cutting attachment
mounting face is pointing up.
Mounting Hardware for Cutting
Attachment
The mounting hardware supplied
depends on the cutting attachment that
comes as original equipment with the
new machine.
The appropriate deflectors and
mounting hardware are available as
special accessories for subsequently
equipping the machine with different
cutting attachments – see chapter on
"Special Accessories".
WARNING
Always use and assemble the cutting
attachment mounting hardware as
described in the chapter on "Mounting
the Cutting Attachment".
FS 510 C, FS 560 C
Publicidad
