Publicidad
Idiomas disponibles
Idiomas disponibles
English
Fitting the Thrust Plate
1
2
Slip the thrust plate (1) over the
N
shaft (2).
Blocking the Shaft
2
1
3
The shaft (2) must be blocked to install
and remove cutting attachments.
The shaft (2) can be blocked only if the
thrust plate (1) is properly fitted – the
stop pin (3) has to engage the thrust
plate.
Insert the stop pin (3) in the bore in
N
the gearbox – apply slight pressure.
Rotate shaft or cutting attachment
N
until the stop pin slips into position
and blocks the shaft.
The stop pin is held in position in the
gearbox by a rubber element.
26
Fit or remove the cutting attachment
N
– see chapter on "Mounting the
Cutting Attachment".
Remove the stop pin from the
N
gearbox.
NOTICE
Always remove the stop pin used to
block the shaft since the drive train will
otherwise be damaged when the engine
runs.
Mounting the Cutting Attachment
WARNING
Use a deflector that matches the cutting
attachment – see "Mounting the
Deflector".
Fitting Mowing Head with Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
All approved mowing heads are
mounted to the gearbox in the same
way.
Check that the deflector on the
N
machine is approved for mowing
heads – if not, perform the next two
steps.
Remove grass shield with thrust
N
plate – if fitted.
Remove the non-approved
N
deflector.
Mount deflector for mowing heads.
N
Fit grass shield together with 60 mm
N
(2.4 in) diameter thrust plate.
1
Screw the mowing head
N
counterclockwise on to the shaft (1)
as far as stop.
Block the shaft.
N
Tighten down the mowing head
N
firmly.
NOTICE
Remove the tool used to block the shaft.
Remove the mowing head.
Block the shaft.
N
Unscrew the mowing head
N
clockwise.
FS 510 C, FS 560 C
Publicidad
