Progress PBN 1310 Manual De Instrucciones página 14

14 progress
7. Release the locking system to remove the
internal panes of glass
8. Turn the 2 fasteners 90° and extract them
from their seats
9. Carefully lift the top pane out a little and
Clean the oven door with lukewarm water
and a soft cloth. Do not use any scourers,
metal wool, abrasive sponges or acids which
could damage the heat reflecting special sur-
faces of the inner pane.
After cleaning the inner pane put back in the
door. Insert the door in the oven; proceed in
reverse order. Be mindful of the correct align-
ment of the panes.
To perform this operation correctly, proceed
as follows:
1. The inner pane with the frame on four
2. The inner pane must be put in its place
90°
After putting the panes in the oven door, se-
cure them in reverse order, following the
guidelines in Point 8 .
pull out the pane which is visible on all
four sides of the frame.
1
sides must be installed so that the screen
faces the outside of the oven. Touch the
visible surface. If there is no roughness on
the level of the screen, the pane is inser-
ted correctly.
according to figure.
2