Toshiba RAV-SM564UT-E Manual De Instalación página 28

+00EH99858901_01EN_4-way_IM_printOnly.book Page 27 Tuesday, December 4, 2007 2:31 PM
4-way Air Discharge Cassette Type
Procedure example ➀
Manual address setup procedure
While the operation stops, change the setup.
(Be sure to stop the operation of the unit.)
3
-2,
4
-2,
5
-2
7
Procedure
Push simultaneously
seconds or more. After a while, the display part
flashes as shown below. Check the displayed
CODE No. is [10].
• When the CODE No. is other than [10], push
button to erase the display and repeat
procedure from the first step.
(After pushing
remote controller is not accepted for
approx. 1 minute.)
(For a group control, No. of the firstly displayed
indoor unit becomes the header unit.)
Procedure
Every pushing
in the group control is displayed in order. Select
the indoor unit of which setup is changed.
In this time, the position of the indoor unit of which
setup is changed can be confirmed because fan
and louver of the selected indoor unit operate.
Procedure
1. Using temp. setup
CODE No. [12].
(CODE No. [12]: Line address)
2. Using timer time
line address from [3] to [2].
3. Push
In this time, the setup finishes when the display
changes from flashing to lighting.
27-EN
7
3
4
5
3
4
5
1 2,6
1
+ + buttons for 4
button, operation of the
(* Display changes according to
the model No. of indoor unit.)
2
button, the indoor unit No.
3
/ buttons, specify
/ buttons, change the
button.
Indoor unit No. before setup change is displayed.
-1,
-1,
-1,
4
Procedure
1. Using temp. setup
CODE No. [13].
-3,
(CODE No. [13]: Indoor address)
-3,
2. Using timer time
-3,
indoor address from [3] to [2].
3. Push button.
In this time, the setup finishes when the display
changes from flashing to lighting.
Indoor unit No. before setup change is displayed.
5
Procedure
1. Using temp. setup
CODE No. [14].
(CODE No. [14]: Group address)
2. Using timer time
setup data from [0001] to [0002].
(Setup data [Header unit: 0001] [Follower unit:
0002])
3. Push button.
In this time, the setup finishes when the display
changes from flashing to lighting.
Indoor unit No. before setup change is displayed.
– 27 –
Installation Manual
/ buttons, specify
/ buttons, change the
/ buttons, specify
/ buttons, change the
Toshiba XXXXXXX(X/X)