Toshiba RAV-SM564UT-E Manual De Instalación página 30

+00EH99858901_01EN_4-way_IM_printOnly.book Page 29 Tuesday, December 4, 2007 2:31 PM
4-way Air Discharge Cassette Type
How to set up 8°C
Operation
Preheating operation can be set for cold regions
where room temperature drops to below zero.
Procedure
Push simultaneously
seconds or more when the air conditioner is not
working.
After a while, the display part flashes as shown
below. Check the Displayed CODE No. is [10].
• When the CODE No. is other than [10], push
button to erase the display and repeat
procedure from the first step.
(After pushing
remote controller is not accepted for approx. 1
minute.)
Procedure
Every pushing
in the group control is displayed in order. Select
the indoor unit of which setup is changed. In this
time, the position of the indoor unit of which setup
is changed can be confirmed because fan and
louver of the selected indoor unit operate.
Procedure
Using temp. setup
CODE No. [d1].
Procedure
Using timer time
DATA [0001].
Setup data
0000
0001
Procedure
Push button.
In this time, the setup finishes when the display
changes from flashing to lighting.
Procedure
Push button.(Setup is determined.)
When pushing
and the status
Becomes the usual stop status. (When pushing
button the operation from the remote
controller is not accepted for approx. 1 minute.)
29-EN
1
+ + buttons for 4
button, operation of the
(* Display changes according to
the model No. of indoor unit.)
2
button, the indoor unit No.
3
/ buttons, specify
4
/ buttons, select SET
8°C Operation setting
None
(Factory Shipping)
8°C Operation setting
5
6
button, the display disappears
– 29 –
Installation Manual
Toshiba XXXXXXX(X/X)