golmar Stadio Plus Manual De Instalación página 54

DOOR PANEL INSTALLATION
Plug the EL560 module in the CN6 connector.
NOTE: on this type of installations the EL561 module
M
emory banks.
The door panel has two memory banks
to plug 256Kb memory modules in.
Each module allows to record the custom
text for a maximum of 1000 users.
The system is delivered with one memory module
placed in the bank number 0 (BK0), where
the system configuration will be recorded.
IMPORTANT: in case of door panels with two memory modules,
don't change their bank position once they have been recorded.
BK0 bank module must always have a memory module plugged in.
C
omputer connection.
It's possible to program the door panel using a
computer through its RS-232C port.
An interface (not included) should be connected
to CN8 door panel connector. MEMEDIT software
(included with the interface) will allow to program
the door panel and to save a copy of each system.
In case of memory damage it will be possible
to restore the system configuration from the computer.
O
ptional. EL560 module for video installations
with twisted pair cable.
The CN4 connector is accessible by unbolting
the four screws of the pcb protection cover.
must be plugged in all the monitors.
Refer to the specific installation diagram.
BK1
BK0
104 105
I
nformative module lamps wiring.
Once the informative labels are placed, wire the
lamps from different modules and connect them
to terminals L1 and L2 of the sound module.
F
inal adjustments.
If after starting the system it's considered that the audio
volume isn't correct, proceed with the necessary
adjustments as shown.
The telecamera has a pan and tilt mechanism built in
to adjust the telecamera position.
In case of low light conditions, an external illumination
can be activated by connecting a R-3 relay
between terminals '+H' and 'L2' of the sound module.
C
lose the door panel.
Fix the door panel by using the supplied
screws.
Finish the door panel assembly by pressing
the closing heads.
DOOR PANEL INSTALLATION