golmar Stadio Plus Manual De Instalación página 60

DOOR PANEL PROGRAMMING
To introduce or edit text during programming, use the keypad as described. The maximum
number of characters in one text line is 16.
Use the numeric keys to introduce text: press several times the corresponding key till the
desired character appears on the display, according with the enclosed characters table.
Use the arrow keys to move through the display.
Use the key symbol to delete the actual character. The rest of the text
will be moved one position backward.
Press OK to record the whole text. The display
will show the message
O.K.
Press CANCEL key to exit from edition. The former text will be restored
C
and the display will show the message
ANCEL
1 2
4 5
7 8
0
For fast searching press one of the arrow keys followed by the number of entries to be
skipped. For a faster search use arrow keys followed by number 0 (10 in 10 entries)
or key symbol (100 in 100 entries).
The search is realized of 5 in 5 entries. From that moment, each time
5
an arrow key is pressed the repertory advances 5 in 5 entries.
116
T
ext edit.
.
settings recorded
.
cancelled
3
6
9
F
ast repertory search.
117
POWER SUPPLY INSTALLATION
I
nstalling the FA-PLUS and FA-PLUS/C power supplies.
3,5 x 25
DIN-7971
To install the power supply directly on the wall, drill two holes
of Ø6 mm. and insert the wallplugs.
Fix the transformer with the specified screws.
3,5 x 25
DIN-7971
The power supply can be installed on a DIN 46277 guide
simply pressing it. To disassemble the power supply
from the DIN guide, use a plain screwdriver to lever
the flange as shown on the picture.
The FA-Plus/C model uses 6 units over DIN guide
and 10 units the FA-Plus model.
IMPORTANT: the maximum number of units that can be connected to a FA-Plus/C power
supply is 10, and 50 units in case of a FA-Plus model.
Link power supplies to connect more units than the specified as it's shown
on page 127.
LOCK RELEASE INSTALLATION
L
ock release installation.
If the lock release will be installed in a metal door, use a
Ø3,5mm. drill and tap the hole . In case of wood door,
use a Ø3mm. drill .
IMPORTANT: the lock release to be used must be of 12Vd.c.
If you are using a.c. lock releases, use one R-3 relay unit and
one TF-104 transformer to activate it, as it is shown on page 127.
The power supply must be installed in a dry and
protected place. It's recommended to protect
the power supply by using a thermo-magnetic
circuit breaker and to use a ground connection.
DIN 46277
3,5 x 25
DIN-7972
M 4 x 8
DIN-963