golmar Stadio Plus Manual De Instalación página 63

MONITOR INSTALLATION
F
ix the monitor connector to the wall.
Avoid to place the monitor near to heating sources,
in dusty locations or smoky environments.
To install the monitor directly over the wall,
drill two holes of Ø6mm. and use the supplied screws.
The upper part of the monitor connector must be placed
at 1,60m. height roughly. The minimum distance
between the monitor connector and the closest object
must be 5cm.
F
ix the monitor.
122
Place the monitor at right angles to the connector
and align the attaching holes of the monitor
with the attachment hooks of the connector,
as it is shown on the drawing.
Lock out the monitor. Press the right side
till the attachment clip locks the monitor
firmly.
To disassemble the monitor from the connector,
use a plain screwdriver to release the
attachment clip. Remove the monitor from
the connector, with special attention do not
falls.
123
MONITORS PROGRAMMING
P
rogramming the monitors.
In case of a general entrance door panel, program the monitors only from each internal
building door panel, as described on the corresponding instruction manual.
If this door panel is installed on an internal building of a residential complex or on a single
building, program the monitors as follows:
golmar
13:15
Switch off the monitor to be programmed.
Once the monitor is off, press the door release push button.
With the door release push button pressed
switch on the monitor.
To show that the system is ready for programming, the panel
will reproduce a sound and the LCD will display the
message
on the monitor. At this moment, the door release
push button can be released. Lift the handset to stablish
audio communication with the door panel.
1 0
O.K.
Each apartment must have one master unit only; in case of parallel units configure them
as slaves, both monitors or telephones.
Repeat these steps to program the rest of monitors.
Once the programming has been finished exit from the programming menu by pressing
CANCEL key. If you don't, the door panel will automatically exit after 90 seconds
with no operation.
To enter the door panel into program mode, press
key symbol and enter the installer PIN code
(factory default: 1315), as described on page 106.
program mode , appearing the picture
Enter the code of the monitor to be
programmed and press the bell key.
At this moment the panel will reproduce
a sound and the monitor led will blink.
To program the monitor as master, switch it
off and on again.
To program it as slave, press the door
release push button.
To program it as slave with intercom
function press the push button.