golmar Stadio Plus Manual De Instalación página 58

DOOR PANEL PROGRAMMING
Coming from previous page
3 code on
rd
07:15
modify value
07:15
1 0 1 3
3 code on
rd
10:13
3 code off
rd
14:55
panic code
:5555
End of the access control menu. Use "UP" arrow key to move to the previous options.
Press CANCEL to exit from the access control menu and return to the main menu.
If CANCEL is pressed twice the panel will exit from the programming menu.
A
ccess control menu.
Defines the starting time from which
it's possible to activate the lock release
by entering the third code.
To set this time press OK: the display will show
the message . Key in
modify value
O.K.
the hour value from 0 to 23 and minutes
value from 0 to 59 and confirm by pressing
OK. If CANCEL is pressed the former value
will be restored.
For a proper operation of this function,
the system clock must be correctly adjusted,
as described on page 108.
O.K.
Defines the closing time from which
it's possible to activate the lock release
by entering the third code.
To set this time proceed as described on the
previous menu.
In case that starting and closing times have
equal values, the third code will be enabled
all the time.
Proceed as described on "1st code" to modify
the fourth code. When this code is used
to activate the lock release, the system sends
an alert message to the porter's exchange
(if exists).
Continue
112 113
Coming from previous page
repertory
repertory:new
enter address
enter direct cod
0 0 3
enter name
_
setting recorded
NOTE: to make a call it will not be necessary to enter the zero placed on the left side
DOOR PANEL PROGRAMMING
To enter into repertory menu, follow
the steps described on page 106
O.K.
and press OK when the display shows the
message
repertory
Allows to enter a new entry in the last repertory
position. To choose a specific position,
use the
repertory:insert
Press OK to proceed: the display will show
the message
enter address
O.K. monitor code and confirm by pressing OK.
If the panel has been configurated as general
entrance door panel, a six digits code must
:000
be entered: the three first digits will match the
internal building code and the three last
1 0 2
digits will match the monitor code.
If the panel has not been configurated as
O.K.
general entrance door panel, a three digits
code will be required, that will match the
monitor code.
IMPORTANT: if "Direct Call Code" function
has been enabled (page 108), the display
:000000
will show the message
enter the six digits code that will be used
4 0 9
to call to this apartment.
Press OK to validate it.
O.K.
To assign a text to this entry press OK and
proceed as described on page 116.
Once the new entry has been recorded
the display will show the message
settings recorded
to the initial screen. Repeat this procedure
to add as much entries as it is needed.
of the call code. For instance, if the call code is 000100, it will be enough to
enter 100 to make the call.
R
epertory menu.
.
menu.
; key in the
;
enter direct cod
, and will return
Continue