Dreame DreameBot L10S Ultra Manual De Usuario página 13

Before Use
1. Remove the protective strips
2. Install the Side Brush and the Mop Assembly
Side Brush Clip
Note: Install the side brush until it clicks into place.
3. Connect to An Electrical Outlet
Place the base station in a location that is as open as possible with a good Wi-Fi
signal. Insert the power cord into the base station and plug it into the socket.
Firmly insert the power
cord upwards until the
indicator turns on.
4. Place the Base Station
Remove any objects that are closer than 1.5 m from the front, 1 m from the top,
and 0.5 m from either side of the base station.
> 0.5 m
> 1.5 m
Note:
·
Make sure that no objects might block the signaling area.
·
To prevent water stains from wetting wood floors or carpets, placing the base
station on tile floors or marble floors is recommended.
> 1 m
> 0.5 m
11
EN