Publicidad
Idiomas disponibles
Idiomas disponibles
Before Use
EN
5. Place the Robot
Press and hold the
button on the robot for 3 seconds to turn it on. Place
the robot onto the base station with the mop assembly facing toward
the washboard. Then you will hear a voice notification when the robot
successfully connects to the base station and starts charging. After the robot
is fully charged, the status indicators on the robot and the base station will
remain lit for 10 minutes and will then dim.
Note: It is recommended to fully charge the robot before its first use. When the
robot cannot be turned on after the battery is depleted, manually connect the
robot with the station to charge it.
6. Install the Cleaner Bottle
Remove the cap of the cleaner bottle, and tear off the seals on the upper and
bottom of the bottle. Open the upper cover of the base station and take out
the clean water tank and the used water tank. Install the cleaner bottle along
the slot into place. The cleaner will be added automatically while working.
12
①
②
Note:
·
Remove the soft rubber plug in the cleaner adding inlet before first use.
·
Do not add any liquid other than the officially-approved cleaner to help prevent
base station malfunction.
7. Add Water to the Clean Water Tank
Fill the clean water tank with clean water up to the maximum water level
mark, and then install the clean water tank and the used water tank in place.
Note: Do not add hot water to the water tank, as this may cause the tank to become
deformed.
③
MAX Water Line
Publicidad
