Dreame H12 Manual Del Usuario página 8

How to Use
EN
Starting Cleaning
Briefly press the button to power on, and the vacuum will start cleaning. The vacuum
comes with an upright/reclining switch. Please gently step on the brush cover and
recline the vacuum backwards to start operating. If the vacuum is in the upright position
while working, the current task will be suspended.
Note: When the vacuum is working, neither move it off the ground nor lay it flat. Otherwise, the dirty
water may flow into the motor.
＜140°
Do not recline the vacuum backwards more than 140° to prevent the vacuum from
leaking water.
Do not use to vacuum any foamy liquids.
Auto Mode / Suction Mode
The vacuum is powered on by default in Auto mode, you can switch to the Suction mode
based on your needs.
Auto Mode: The vacuum can adjust its suction power depending on different situations.
Suction Mode: The vacuum can clean the water stains on the floor.
11
Care & Maintenance
Tips:
1. Turn off the vacuum before care and maintenance.
2. Replace parts if needed. The parts must be replaced by those available from the
manufacturer or its service agent.
3. If the vacuum is not used for an extended period, fully charge it, unplug the power
adapter, and store the vacuum in a cool, low-humidity environment away from direct
sunlight. To avoid over-discharge of the battery, charge the vacuum at least once
every 3 months.
One-Touch Self-Cleaning
* The self-cleaning function can be enabled only when the vacuum is being charged and the battery
level is more than 15%.
1. After the vacuum completes the cleaning task,
place it back onto the base and make sure that
the water in the clean water tank is sufficient for
self-cleaning.
2. Briefly press the self-cleaning button on the top
of the handle, the self-cleaning indicator will
light up, and the vacuum will start self-cleaning.
3. After the self-cleaning ends, the vacuum
continues charging its battery.
Note: After the vacuum completes self-cleaning, clean the used water tank promptly. If some stains
are left on the charging base, clean the base .
EN
12