Makita DCL182 Manual De Instrucciones página 15

3. Insert the dust case all the way until the two but-
tons lock with a click.
2
► 1 . Dust case 2. Button (two locations)
NOTE: Check that the cyclone attachment, cleaner,
and straight pipe are all firmly connected before
restarting operation.
NOTE: If the suction force does not recover even
after disposing of the dust and cleaning the mesh
filter, check whether dust has accumulated in the dust
bag of the cleaner or clogging has occurred.
Cleaning
When the dust case becomes dirty or the mesh filter is
clogged, remove and wash them with water. (Refer to
"Disposing of dust" for the removal procedure.)
Dry the parts thoroughly before reinstallation and use.
1
► 1 . Dust case 2. Mesh filter
When the mesh filter gets dirty badly, clean it in the
following procedures.
1.
it while the hooks are unlocked.
1
► 1 . Mesh filter 2. Hook
2.
it with water. After that, dry it thoroughly.
3.
are aligned with the port. Turn the mesh filter clockwise
until the hooks are locked with a click. Make sure that
the mesh filter is installed securely.
2
► 1 . Mesh filter 2. Hook 3. Port
15 ENGLISH
Turn the mesh filter counterclockwise and remove
Remove the dust on the mesh filter and then wash
Insert the mesh filter into the base while the hooks
1
1
2
2
3