Parkside PBK 4 B3 Traducción Del Manual De Instrucción Original página 58

GB MT
• Always hold the device tightly with
both hands, with one hand on the rear
handle and the other hand on the front
round handle (
Your thumb and fingers must tightly
clasp the handles.
• Check the shoulder strap (
comfortable positioning which facili-
tates holding the hedge trimmer.
• If the blades become jammed with
solid objects, switch the device off
immediately, pull the mains plug or re-
move the batteries and then remove the
object.
• Avoid over-stressing the device while
working.
Working with the pruner
If the saw chain gets stuck,
do not attempt to pull out the
pruner with force. There is a risk of
injury. Switch the engine off and
use a lever arm or wedge to re-
lease the pruner.
• The saw chain should have reached its
maximum speed before you begin saw-
ing.
• You will have better control over the
device if you saw using the lower edge
of the blade bar (saw chain in pulling
direction) and not using the upper edge
of the blade bar (saw chain in pushing
direction).
• The saw chain must not touch the
ground or any object while sawing
through the material or thereafter.
• Ensure that the saw chain does not get
stuck while sawing. The log must not
break or splinter.
• Please also observe the precautionary
measures to protect against kickback
(see the safety information).
58
9).
A
29) for
A
• Remove branches hanging downwards
by sawing from the top of the branch.
• Twisted branches must be individually
cut down to size.
Working using the spool
• In small grass areas hold the device at
an angle of about 30° and swing the
cutting head evenly to the right and left
with a semi-circular movement.
• The best results are obtained with a
maximum grass length of 15 cm. If the
grass is taller, it is recommended to
mow several times.
• To cut around trees, fence posts or oth-
er obstacles, slowly move the device
around the obstacle and cut with the
thread ends.
• Avoid any contact with fixed obstacles
(rocks, walls, picket fences, etc.). The
thread would wear out quickly. Use the
edge of the protective cover to keep the
device at the correct distance.
Caution! Do not lay the cut-
ting head on the ground
during operation!
Working with the 3-tooth
blade
Always wear the shoulder
strap and suitable protective
clothing when working with the
device. Wear eye, hearing and
head protection.
Ensure that the blade is installed
correctly. Replace damaged or
blunt tool parts.
There is a risk of injury.
Only use the blade to work on
open, even areas. Carefully inspect