Cleaning And Sterilization; Cleaning - Sirona Dental SIROLaser Instrucciones De Uso

7 Cleaning and sterilization

42
7
Cleaning and sterilization
Following treatment, switch off the laser and disconnect the power cord from
the power supply.
WARNING
The handpieces and the reusable tips are delivered in non-sterilized condition.
They must be sterilized before initial use as well as prior to each further use.
WARNING
Disinfect the finger switch and the optical fiber before initial use and prior to
each further use.
Laser protective goggles
Before cleaning the laser protective goggles, please read and observe the
instructions for use provided by the manufacturer and attached to the goggles
in the case.
7.1

Cleaning

i
NOTICE
Manual cleaning must always be combined with disinfection.
i
NOTICE
All tissue residues must be removed from the optical fiber before it is detached
from the handpiece. This prevents internal contamination of the tip.
Following treatment:
Optical fiber
CAUTION
Reattach the black protective cap to the (laser) end of the connector before
taking any hygienic measures.
Remove the optical fiber from the handpiece.
Notch the optical fiber approx. 4 cm from its distal end. The notch must
be made perpendicular to the axis of the optical fiber.
Remove approx. 4 cm of the sheath if necessary (see Chapter 4.8.4,
page 27).
The take-up reel and optical fiber must be disinfected first.
After it is removed from the reel, the optical fiber can be cleaned with a
suitable brush under running water (of at least drinking water quality).
Handpiece
Remove the tip from the handpiece.
Disassemble the handpiece by unscrewing the two threaded joints.
Clean the handpiece and the reusable tip with a suitable brush under
running water. Clean the distal end of the optical fiber using a soft, damp
cloth.
If a finger switch is installed, remove it as described in Chapter 4.7
60 56 092 D 3485
D 3485.201.01.10.02 03.2008