Publicidad
Idiomas disponibles
Idiomas disponibles
cleaning
•
Always unplug the appliance from the mains before cleaning and then wash your
hands.
•
Never immerse the vacuum sealer in water or any other liquid.
•
Never clean with abrasive detergent products or scouring pads.
•
Clean outer surfaces of the appliance using a soft damp cloth (no detergent) before
and after use.
•
Use paper towel to clean the inside of the appliance.
•
Liquids sucked from the bags may collect in the vacuum chamber: if this happens,
clean using a slightly damp cloth and a mild detergent. Next, rinse with fresh water and
dry thoroughly with a clean, dry cloth.
•
Clean the provided accessories (hose, stopper) and detachable parts (heat strip and
bottom seal) with warm soapy water. The surfaces should then be rinsed with fresh
water and carefully dried using a soft cloth.
•
Thoroughly dry all parts of the appliance and its accessories before using it again.
•
Keep the appliance's lid unlocked when not in use.
storage
•
Store your vacuum sealer flat in its original packaging and in a cool, dry place, out of
reach of children.
•
The power cord folds away in its compartment underneath the appliance (see Figures 18
and 19 below).
Figure 18
26
troubleshooting guide
Before contacting your retail store's after-sales service counter, try the following steps.
The appliance doesn't work when I press the
•
Check that the power cord is not damaged, that it is plugged in correctly and that the
power point is working. To check, plug a different appliance into the socket in question.
If it still does not work, check the circuit breakers or fuses in your home.
•
Make sure the bag is placed correctly inside the vacuum chamber.
•
Lower the lid and make sure it is properly closed. You should hear a click when each
side locks. Press down firmly.
•
Wait long enough to allow the appliance to cool down between uses.
•
If you use the provided hose, make sure it is properly connected to the appliance and to
the airtight container or vacuum stopper.
The bag is not properly sealed:
•
Make sure there are no creases or holes in the pre-sealed bags.
•
Check the condition of the top and bottom seals; make sure they are free of wear,
cracks and damage.
•
Check that the bag is inserted correctly into the vacuum chamber. Resume vacuum
packing, holding the bag with both hands and gently stretching it to keep it flat before
closing the lid.
•
Check that the heat strip is perfectly clean when heat sealing.
•
Moisture from highly liquid foods may prevent the bag from sealing properly. Cut the bag
and leave it open, clean and dry the inside and then re-seal the bag.
•
This may be caused by the heat strip overheating during the sealing process. Give the
appliance time to cool down sufficiently between uses. Leave the appliance to cool
down for 30 minutes with the lid open before using it again.
Do not attempt to repair this appliance yourself. If you are unable to solve your specific
problem using the above information, bring the appliance to your retail store's after-sales
service counter.
Figure 19
button or the
button:
27
Publicidad
