Publicidad
Idiomas disponibles
Idiomas disponibles
Temperature Dry Well Calibrators/Micro Calibration Baths
CTD9100/CTB9100
13.2 Technical data CTD9100
GB
Technical data CTD9100
Display range/Setting range
CTD9100-165
CTD9100-450
CTD9100-650
Temperature setting range
CTD9100-165
CTD9100-450
CTD9100-650
Block temperature control
Setting the temperature
Accuracy
CTD9100-165
CTD9100-450
CTD9100-650
Control stability
Block temperature display
Display resolution
Ambient temp. influence
(0 ... 50 °C) to the accuracy
Excess temperature behaviour
Sensor break behaviour
Display unit
Display for sensor break
Detection speed
Controller outputs
Power supply
CTD9100-165
CTD9100-450
CTD9100-650
30
WIKA Operating Instructions Temperature Dry Well Calibrators/Micro Calibration Baths
-50.0 °C to +165.0 °C in 0.1 °C resolution
0.0 °C to +450.0 °C in 0.1 °C resolution
0.0 °C to +650.0 °C in 0.1 °C resolution
between -30 °C and +165 °C
between room temperature and 450 °C
between room temperature and 650 °C
via PID controller
via the P key and the 5 or key to 0.1 °C
fine adjustment occurs automatically
+/- 0.15 K ... 0.25 K
+/- 0.30 K ... 0.50 K
+/- 0.30 K ... 0.80 K
+/- 0.05 °C
4-digit, 7-segment LED, 7 mm high
red = PV, green = SV
+/- 0.1 °C
+/- 0.02 °C/°C
temperature fuses interrupt the power supply if there is excess
temperature inside the housing
the control is switched off
°C or °F (optional)
- - - -
130 ms
1 x voltage output for control of the solid state relay (8 mA/8
VDC), heater control
1 x voltage output for control of the solid state relay (8 mA/8
VDC), cooling control
1 x relay SPDT (8 A-AC1, 3 A-AC3/250 VAC)
100,000 switching cycle, fan control
90 ... 240 VAC +/- 10 %, 50/60 Hz
230 VAC -15 %/+10 %, 50/60 Hz
230 VAC -15 %/+10 %, 50/60 Hz
optional 115 VAC -20 %/+10 %, 50/60 Hz
Publicidad
