Publicidad
Idiomas disponibles
Idiomas disponibles
Temperature Dry Well Calibrators/Micro Calibration Baths
CTD9100/CTB9100
1. Device Description and Intended Use
GB
The calibrator/micro calibration bath is a portale unit
for service, industry and laboratory tasks. The WIKA
temperature calibrators/micro calibration baths are
intended to calibrate thermometers, temperature
switches/thermostats, resistance thermometers
and thermal elements. The operational safety of the
supplied instruments is only guaranteed if they are
operated according to their intended use (inspection
of temperature sensors). Specified limit values (see
"Technical Data") should never be exceeded.
It is your responsibility to select the instrument
which is suitable for your specific application,
to connect it correctly, to carry out tests and to
maintain all the components.
Various instrument versions are manufactured.
The respective type label on the calibrator/micro
calibration bath displays the version of each device.
These operating instructions apply to the following
calibrator/micro calibration bath types:
Fig. 1: Temperature calibrator
CTD9100-650
The front part of the housing contains the com-
plete electronic unit for controlling the reference
temperature.
Solid state relays (SSR) are used to control the
heating and cooling elements.
4
WIKA Operating Instructions Temperature Dry Well Calibrators/Micro Calibration Baths
Temperature calibrators
CTD9100-165 (cooling and heating)
CTD9100-450 (heating)
CTD9100-650 (heating)
Micro calibration baths
CTB9100-165 (cooling and heating)
CTB9100-225 (heating)
The calibrator/micro calibration bath consists of a
rugged grey and blue steel housing with carrying
handle.
The rear part of the housing contains a metal
block/liquid bath with a hole, accessible from the
top, for the test specimen fixture.
The heating or cooling elements and the
temperature sensor for determining the reference
temperature are integrated in the metal block/liquid
bath.
The metal block/liquid bath is heat insulated.
Fig. 2: Temperature calibrator
CTD9100-165
A controller equipped with a 7-segment LED
(2 lines, 4 digits) for the reference and set
temperature is located on the front plate.
The micro calibration bath also has a thumb wheel
for controlling the stirring speed.
Fig. 3: Micro calibration bath
CTB91000-165
Publicidad
