Publicidad
Idiomas disponibles
Idiomas disponibles
When adjusting the blades,
take particular care to avoid
fingers being trapped between
the rotating blades and fixed
parts of the machine.
• Check that only replacement
tools authorised by the manu-
facturer are used.
• Before you shut down the ma-
chine, let the motor cool down.
Residual Risks
Even if properly operating and
handling this electric tool, some
residual risks will remain. Due
to its construction and build, this
electric tool may present the fol-
lowing hazards:
a) Cuts
b) Ear damage if working without
ear protection.
c) Damage to your health caused
by swinging your hands and
arms when operating the appli-
ance for longer periods of time
or if the unit is not held or main-
tained properly.
Warning! During operation,
this electric tool generates an
electromagnetic field which,
under certain circumstances,
may impair the functionality
of active or passive medical
implants. To reduce the risk
of serious or lethal injuries,
we recommend that per-
sons with medical implants
consult their doctor and the
manufacturer of their medical
implant before operating the
machine.
Assembling instructions
•
Alwayas wear cut-protection gloves
•
Undertake only work with which you
are confident.
•
In case of uncertainty, contact a spe-
cialist or contact our service directly
Install lower bar
1. Open the lower bar (4) and move it to
the desired inclination.
2. Fix the lower bar by means of the pre-
mounted quick-release levers (5).
Install curved handle
1. Fasten the bow-type handle (1) with
the screws and the upper quick-re-
lease levers (2) to the right and left of
the lower bar (4)..
2. Clipping in the cable holders: Clip the
cable holders (
bar to fixate the machine cable
(
16).
If you loosen the quick release le-
vers, you can fold down the curved
handle and the lower part of the
handle for storage of the device.
Installing the grass box
The collection box is already completely
preassembled.
1. Loosen the Phillips screw (20a) on the
carrying handle (20).
2. Place the carrying handle (20) on
the upper side of the grass collection
box (13) and screw it tight with a Phil-
lips screw (20) from below.
3. Place the plastic tabs (13a) over the
grass collection box rods (13b).
GB
15) onto the lower
27
Publicidad
