GreenWorks G48GTE30 Manual Del Operario página 11

• Keep the air vents clean and free of debris to avoid
overheating and damage of the motor.
• Do not spray water onto the motor and electrical
components.
6.3 REPLACE THE SPOOL
Figure 20 - 24.
1. Simultaneously press the tabs on the sides of the
trimmer head.
2. Pull and remove the spool cover.
3. Remove the spool.
4. Replace with a new spool.
Make sure that the cutting line is in the guide slot
on the new spool, and is extended approximately 13
cm. before you install the new spool.
5. Put the end of the cutting line through the eyelet.
6. Extend the cutting line to release it from the guide
slot in the spool.
7. Push the tabs and install the spool cover onto the
spool housing.
8. Push the spool cover until it clicks into position.
6.4 REPLACE THE CUTTING LINE
Figure 25 - 27.
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of 1.65 mm
diameter.
1. Cut a piece of cutting line approximately 3 m
long.
2. Bend one end of the line approx. 6 mm.
3. Insert the line into the anchor hole of the spool.
4. Wind the cutting line around the spool tightly in
the indicated direction.
IMPORTANT
Failure to wind the line in the indicated direction will
cause the trimmer head to operate incorrectly.
5. Put the cutting line in the line slot.
6. Do not wind the cutting line beyond the edge of
the spool.
English
NOTE
NOTE
NOTE
7 TRANSPORTATION AND STORAGE
Remove the battery pack from the machine before
transportation and storage.
7.1 MOVE THE MACHINE
When you move the machine, you must:
• Wear gloves.
• Stop the machine.
• Remove the battery pack and charge it.
• Assemble the blade guard.
7.2 STORE THE MACHINE
• Remove the battery pack from the machine.
• Make sure that children cannot access the machine.
• Keep the machine away from corrosive agents such
as garden chemicals and de-icing salts.
• Secure the machine during transportation to prevent
damage or injury. Clean and examine the machine
for any damage.
7
WARNING
EN