GreenWorks G48GTE30 Manual Del Operario página 9

2. Remove the screw from the guard with a Phillips
head screwdriver (not included).
3. Put the guard onto the trimmer head.
4. Align the screw hole on the guard with the screw
hole on the trimmer head.
5. Tighten the screw.
4.3 ATTACH THE WHEEL
Figure 5 - 6.
1. Remove the screw from the wheel with a Phillips
head screwdriver (not included).
2. Put the wheel onto the trimmer head.
3. Align the screw hole on the wheel with the screw
hole on the trimmer head.
4. Tighten the screw.
4.4 ATTACH THE AUXILIARY HANDLE
Figure 7 - 8.
1. Remove the knob from the handle.
2. Attach the auxiliary handle on the shaft.
3. Set the auxiliary handle in the comfortable
position.
4. Tighten the auxiliary handle with the knob.
5 OPERATION
This section describes how to operate the product.
WARNING
Carefully read and understand the safety chapter
and operation instructions before you operate the
product.
5.1 INSTALL THE BATTERY PACK
Figure 9.
WARNING
• If the battery pack or charger is damaged, replace
them directly.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, understand, and follow the instructions in
the battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery slot.
2. Push the battery pack into the battery slot until
the battery pack locks into place.
3. When you hear a click, the battery pack is
installed.
5.2 REMOVE THE BATTERY PACK
Figure 9.
1. Push and hold the battery release button.
English
2. Remove the battery pack from the machine.
5.3 START THE MACHINE
Figure 10.
1. Push the lock-out button and pull the trigger.
5.4 STOP THE MACHINE
Figure 10.
1. Release the trigger to stop the machine.
5.5 OPERATION TIPS
Figure 11.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Follow these tips when you use the machine:
• Keep a firm hold with both hands on the machine
while you operate the machine.
• Cut tall grass from the top down.
If grass winds around the trimmer head:
• First, remove the battery pack.
• Then, remove the grass.
5.6 CUTTING TIPS
Figure 12.
• Tilt the machine towards the area to be cut. Use the
tip of the cutting line to cut grass.
• Move the machine from right to left to prevent
thrown debris toward the operator.
• Do not cut in dangerous areas.
• Do not force the trimmer head into uncut grass.
• Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood
can wear the cutting line quickly.
5.7 ADJUST THE LENGTH OF THE CUTTING
LINE
Note: The product has an auto-feed head. If the
cutting line does not automatically advance, it is either
tangled or empty.
1. Release the trigger and wait for the trimmer head
to stop completely.
2. Start the trimmer at full speed to automatically
advance the line.
3. Repeat the above steps until you hear the distinct
sound of the line being cut by the cut-off blade.
5
WARNING
WARNING
EN