GreenWorks G48GTE30 Manual Del Operario página 8

EN
1 INTRODUCTION
1.1 PURPOSE
This machine is used to cut grass, light weeds, and
other similar vegetation at or around ground level. The
cutting plane must be approximately parallel to the
ground surface. It also can be used to trim and cut
around the edge of driveways, side walks and more.
1.2 OVERVIEW
Figure 1 - 27.
Lock-out button
1
Trigger
2
Auxiliary handle
3
Upper shaft
4
Telescopic adjustment
5
Lower shaft
6
Cut-off blade
7
Flower guard
8
Trimmer head
9
Support wheel
10
Guard
11
Slot
12
Screw hole
13
Knob
14
Bolt
15
Battery release button
16
Spool cover
17
Tab
18
Spool
19
Spool housing
20
Anchor hole
21
Guide slot
22
Direction of rotation
A
Best cutting area
B
Dangerous cutting area
C
2 GENERAL POWER TOOL SAFETY
WARNINGS
Read all safety warnings, instructions,
illustrations and specifications provided with
this power tool. Failure to follow all instructions
listed below may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
WARNING
English
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or battery-
operated (cordless) power tool.
3 SAFETY
Make sure that you follow all safety instructions.
Refer to Safety Manual.
4 ASSEMBLY
This section describes how to assemble and adjust the
product.
Carefully read and understand the safety chapter
and the assembly instructions before you assemble
the product.
4.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
• If parts of the machine are damaged, do not use
the machine.
• If parts are missing, do not operate the machine.
• If parts are damaged or missing, contact the
service center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in
compliance with local regulations.
For your personal safety, do not insert battery before
the tool is assembled completely.
4.2 ATTACH THE GUARD
Figure 2 - 4.
Do not touch the cut-off blade.
1. Pull the edge guide until the open end on the slot.
4
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING