There is no single correct placement, and
the best position may vary from day to
day.
Warning: Positions 1 & 4 on the
head must not be used in other
modes.
Arm pain treatment:
Microcurrent seems to work better if you
also treat the opposite side of the body
to where the pain is felt (with the second
pair of pads). Also try connecting both
sides of the body by placing one pad at
the site of the pain, and the other on the
opposite side (i.e. left hand to right hand),
for 10 mins.
Pad Advice
•
The electrode pads supplied are
reusable but for single patient use.
The adhesive is a peelable hydrogel
(water based).
•
In
order
to
conductivity through the electrode
pads always ensure that they are in
good condition and tacky.
•
Before use make sure your skin is
clean and dry.
24
obtain
the
best
•
Peel the electrode pads from their
protective plastic shield by holding
and lifting one corner of the pad
and pulling. Do not pull on the
pigtail wire of the pad.
•
After
use
always
electrode pads on the plastic liner
and inside the re-sealable plastic
bag.
•
If the electrode pads dry out,
it
is
recommended
replacement pack. It is possible to
restore some of the adhesion of
the pad by adding a tiny drop of
water on each pad and spreading
around. If too much water is added,
the electrode pad will become
too soft. If that happens, place
the electrodes sticky side up in a
refrigerator for a few hours. This
should help restore some adhesion.
•
In very hot weather the gel on the
electrode pads may become soft.
In such cases place them, still on
their plastic liners and in their re-
sealable bag, into a fridge until they
return to their normal condition.
•
The electrode pads provided are
latex-free.
•
Replace the electrode pads when
they
lose
their
connection may cause discomfort
and skin irritation.
•
The electrode pads must always be
used in pairs (two electrode pads
on each channel), so that the signal
can flow in a circuit.
•
You may feel more sensation in one
pad than the other. This is normal –
replace
the
to
buy
a
stickiness.
Poor