cecotec bolero COOLMARKET TT 107 WHITE Manual De Instrucciones página 58

ENGLISH
dividing he amount of refrigerant load by the total space of the room in which the refrigerator
is installed must not be less than 8 g/m³.
Note:
The amount of refrigerant used by the refrigerator is specified on the appliance marking.
2. Heat dissipation space
During operation, the refrigerator releases heat into the environment. Therefore, you should
leave at least 30 mm of free space at the top chamber, more than 100 mm on both sides, and
more than 50 mm at the rear of the refrigerator.
Dimensions in mm (Fig. 2):
W D H
549 557 845
Note:
Figure 2 only illustrates the space required for the product.
3. Installation surface
Place the refrigerator on a solid, flat surface to keep it stable, otherwise vibrations and noises
will occur. When the refrigerator is placed on a carpet, straw mat, or polyvinyl chloride, solid
support plates should be placed under the refrigerator to avoid colour change due to heat
dissipation.
It is necessary to maintain unobstructed ventilation around the appliance or in the structure
where it is installed.
4. Levelling
Make sure you level your refrigerator with the front levelling feet. If it is not levelled, the door
sealing performance of the refrigerator will be affected, or it can even cause a malfunction.
Preparing for use
1. Waiting time
Once the refrigerator is correctly installed and clean, do not turn it on immediately, wait at
least 4 hours before connecting it to the power supply to ensure normal operation.
2. Cleaning
Check the placement of the interior accessory parts and clean the inside with a soft cloth.
3. Switch-on
Connect the plug into a power socket to switch on the compressor. After one hour, open the
refrigerator door: if the temperature inside the refrigerator compartment has dropped, this
means the cooling system is running normally.
58
A B C(°)
915 1058 125±5
E F
50 100