Parkside PBH 1550 B2 Traduccion Del Manual De Instrucciones Originale página 30

GB MT
Remove the attachment tool.
Fitting the keyed chuck (Fig. C)
1. Unlock the SDS-Plus tool holder (1):
Pull the locking sleeve (3) backwards.
2. Insert the keyed chuck (13) into the
SDS-Plus tool holder (1) by turning it.
3. Clamp the drill chuck: Release the lock-
ing sleeve (3).
4. Check that the keyed chuck (13) is se-
curely locked by pulling on it.
Inserting round shank attachment
tools
1. Place the drill chuck key (15) in one of
the holes on the keyed chuck (13).
2. Open the drill chuck: Turn the drill
chuck key (15) ⭯ .
3. Push the attachment tool as far as pos-
sible into the drill chuck opening (14).
Clamp the attachment tool: Turn the
drill chuck key (15) ⭮ .
Removing round shank attach-
ment tools
1. Place the drill chuck key (15) in one of
the holes on the keyed chuck (13) and
turn the drill chuck key (15) ⭯ .
CAUTION! Risk of burn injury!
2.
Attachment tools – especially drills –
can become very hot. Wear protective
gloves whenever appropriate.
Remove the attachment tool.
Removing the keyed chuck (Fig. C)
1. Unlock the SDS-Plus tool holder (1):
Pull the locking sleeve (3) backwards.
2. Remove the keyed chuck (13).
Adjusting the auxiliary
handle
Notes
• The auxiliary handle (16) can be ro-
tated 360 ° on the device and can be
moved to any desired/necessary posi-
tion.
30
• Directional data viewed from behind.
Attaching the auxiliary handle
(Fig. A)
1. Turn the grip (25) of the auxiliary
handle (16) ⭮ . This extends the loop
(23).
2. Slide the loop (23) on the auxiliary
handle (16) behind the locking sleeve
(3). Position the loop (23) in the holder
for the auxiliary handle (4).
3. Tighten the grip (25) of the auxiliary
handle (16) ⭯ .
Removing the auxiliary handle
(Fig. A)
1. Turn the grip (25) of the auxiliary
handle (16) ⭮ . This extends the loop
(23).
2. Remove the auxiliary handle (16) from
the device by pulling the loop (23) on
the auxiliary handle (16) over the lock-
ing sleeve (3).
Setting the depth stop
(Fig. A)
1. Release ⭯ the locking screw (24) for
the depth stop (18).
2. Push the depth stop (18) into the
small opening on the auxiliary handle
(16). The teeth on the depth stop (18)
should point downwards.
3. Position the depth stop (18) so that the
distance between the tip of the drill
and the tip of the depth stop corres-
ponds to the desired drilling depth.
4. Fix the depth stop (18) by tightening
the locking screw (24) ⭮ .
5. Loosen ⭯ the locking screw (24)
again to move the depth stop (18).