Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
yourself when performing maintenance or
cleaning work. Switch off the device and
disconnect the mains plug from the socket.
You should have any repair and mainten-
ance work that is not described in these
instructions carried out by our Service
Centre. Only use original replacement
parts.
Cleaning
WARNING! Electric shock! Never
spray down the device with water.
NOTICE! Risk of damage. Chemical sub-
stances may attack the plastic parts of the
machine. Do not use any cleaning agents
or solvents.
• Keep the ventilation slits, motor housing
and handles of the machine clean. Use
a damp cloth or brush to do this.
• Clean the SDS-Plus tool holder (1). To
do this, pull the locking sleeve (3) back-
wards and remove the dust cap (2) to-
wards the front.
Maintenance and repair
• Check the device before each use for
obvious defects such as loose, worn or
damaged parts.
• Regularly clean the insertion end of
the SDS attachment tool slightly with
the grease (17) included in the scope
of delivery (0.5 - 1 g). Greasing of
the SDS attachment tool should be
repeated when there is hardly any
grease left on the shaft.
NOTICE! Lubrication of the tool holder
ensures smooth operation and a longer
service life.
Replenishing the grease (Fig. D)
After approx. 50 working hours or when
the impact power decreases, grease
should be refilled.
32
• Open housing cover: Turn the housing
cover (7) with the key included in the
delivery (21) ⭯ .
• Fill with grease. A gear grease for cent-
ral lubrication is suitable.
NOTICE! Risk of damage! The grease
included in the delivery is not suitable
for gearboxes.
• Close housing cover: Turn the housing
cover (7) with the key included in the
delivery (21) ⭮ .
Power cord
• Check the power cord for damage be-
fore each use.
• If the power cord of this device is dam-
aged, it must be replaced by the manu-
facturer or their representative to avoid
safety hazards. contact the service
centre.
Storage
Always store the device and accessories:
• clean
• dry
• protected against dust
• In the case provided (22)
• out of the reach of children
Disposal/
environmental
protection
The device, accessories and packaging
should be properly recycled.
Electrical devices must not be dis-
posed of with domestic waste.
The symbol of the crossed-out wheeled bin
means that this product must not be dis-
posed of as unsorted municipal waste at
the end of its useful life.
Publicidad
