Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Selecting the operating
mode
Notes
• Operate the device only with a moun-
ted auxiliary handle (16). Hold the im-
plement with both hands by the handle
(9) and auxiliary handle (16) while
working.
• Use clamps or another practical
way to secure and support the
workpiece to a stable platform.
Holding the workpiece by your hand or
against the body leaves it unstable and
may lead to loss of control.
• Only operate the function selector
switch when the tool has stopped.
Function
Symbol
Drilling (Striking
mechanism OFF)
Hammer drill (Per-
cussion ON)
Chisel position ad-
justment
Chiselling
Adjusting the chisel position
1. Set the function selection switch (5) to
the
symbol.
2. Turn the attachment tool in the SDS-
Plus tool holder (1) to the required pos-
ition.
3. Use the function selection switch (5) to
select the
symbol for the chisel oper-
ation.
Adjusting the speed
The speed can be adjusted while the
device is in operation. Set the speed con-
trol (11) to the desired level.
Rough guide for speed selection:
Rota-
Drill dia-
tional
meter
speed
Low
Large
High
Small
Switching on and off
WARNING! Risk of injury due to un-
intentional continuous operation of the
tool. Before plugging in the connector,
check that the on/off switch (8) works
properly and returns to the off position
when released.
Switching on
1. Insert the plug in the socket.
2. Press and hold the On/off switch (8).
Switching off
1. To turn it off, release the on/off switch
(8).
2. Wait until the power tool has stopped
before placing it down.
3. Pull the device plug out of the wall out-
let if you are leaving the device unat-
tended or if you have finished working.
Transport
Information on transporting the device:
• Switch off the device and disconnect
the mains plug from the outlet. Make
sure that all moving parts have come to
a complete stop.
• Remove the attachment tool.
• Always carry the device by the handle
(9).
Cleaning, maintenance
and storage
WARNING! Electric shock! Risk of in-
jury due to unintentional start-up. Protect
GB
MT
Materials
Hard
(e.g. metal)
Soft
(e.g. wood)
31
Publicidad
