Kärcher RCV 5 Base Manual página 9

● Short circuit hazard. Keep conductive objects
(e.g. screwdrivers or similar tools) away from the charg-
ing contacts. ● Short circuit hazard. Only clean the
charging contacts of the charging station dry. ● Check
the mains cable for damage each time before every op-
eration. Do not use a damaged mains cable. If dam-
aged, replace the mains cable with an approved
replacement. You can get a suitable replacement from
KÄRCHER or one of our service partners. ● Applies to
RCV 5 devices: Only the cleaning robot model "RCV 5"
may be charged. ● Only use the charging station in
countries with a mains voltage of 220-240V.
ATTENTION
● Use the charging station indoors
only. ● Do not place the charging station near heat
sources, e.g. heaters. ● Store the charging station in-
doors only, in a cool, dry place. ● Charge the cleaning
robot at least once a month to avoid deep discharge of
the battery. ● Switch off the charging station before all
care and maintenance work. ● Do not place objects on
the device or sit on it.
Symbols on the device
Read the operating instructions and all
safety instructions before operating the
device for the first time.
Protect the device from moisture. Store
the device in a dry place. Do not subject
the device to rain. The device is only
suitable for indoor use.
Intended use
● The unit is designed as a suction and charging sta-
tion for use with the KÄRCHER RCV 5 cleaning ro-
bot.
● This device has been developed for use in private
households and is not intended for the load imposed
by commercial use.
Environmental protection
The packing materials can be recycled. Please
dispose of packaging in accordance with the en-
vironmental regulations.
Electrical and electronic devices contain valua-
ble, recyclable materials and often components
such as batteries, rechargeable batteries or oil,
which - if handled or disposed of incorrectly - can
pose a potential danger to human health and the envi-
ronment. However, these components are required for
the correct operation of the device. Devices marked by
this symbol are not allowed to be disposed of together
with the household rubbish.
Notes on the content materials (REACH)
Current information on content materials can be found
at: www.kaercher.de/REACH
Accessories and spare parts
Only use original accessories and original spare parts.
They ensure that the appliance will run fault-free and
safely.
Information on accessories and spare parts can be
found at www.kaercher.com.
Scope of delivery
The scope of delivery for the appliance is shown on the
packaging. Check the contents for completeness when
unpacking. If any accessories are missing or in the
event of any shipping damage, please notify your deal-
er.
Device description
Illustration A
Dust container
1
Motor protection filter
2
Insertion for dust bag
3
Support for cleaning tool
4
Status display
5
Cover
6
Cable management
7
Charging station
8
Charging contacts
9
Suction opening
10
Blower opening
11
Dust bag
12
Mains plug
13
Cover of the dirt receptacle
14
Functional description
The unit functions as a charging and suction station for
the RCV 5 cleaning robot.
As a charging station, the functionality is identical to the
charging station supplied with the cleaning robot.
In addition, the station is used for suction. Suction starts
when the cleaning robot has completed its cleaning
task. However, suction can also be started manually.
During the suction process, a flap in the dust container
of the cleaning robot is opened by the vacuum created
and the dirt is transported into the filter bag of the sta-
tion.
The process can also be started manually.
Suction can only take place under the following condi-
tions:
● The cleaning robot is in the station.
● A filter bag is suspended in the station.
● The inserted filter bag is not full.
● The station cover is closed.
LED display
Flashes green
Lights up green for 1
minute
Lights up permanent-
ly green
Lights up blue
Lights up red
Off
English
Status displays
Status
The cleaning robot is charging.
The cleaning robot is fully
charged.
The cleaning robot is cleaning.
Suction is in progress.
A fault has occurred.
The cleaning robot is charged
and in sleep mode or "Do not
disturb" mode.
9