Stihl FCB-KM Manual De Instrucciones página 10

To reduce the risk of injury
from blade contact, keep
hands and feet away from
cutting area.
!
Warning!
This edger is normally to be used at
ground level with the cutting attachment
perpendicular to the ground. Use of an
edger above ground level or with the
cutting attachment parallel to the ground
may increase the risk of injury, since the
cutting attachment is more fully exposed
and the edger may be more difficult to
control. Never use your edger as a
hedge trimmer.
!
Warning
When using your edger, avoid cutting
close to fences, sides of buildings, tree
trunks, stones or other such objects that
could cause the edger to kick out or
could cause damage to the blade. In
addition, be alert to an increased risk of
ricochets in such situations.
If the edger strikes a foreign object,
follow these steps: stop the engine,
disconnect spark plug lead, inspect for
damage and repair any damage before
restarting and operating the product.
FCB-KM
Do not operate using the starting throttle
lock as you do not have control of the
engine speed. See section of your
KombiEngine owner's manual on the
proper use of the slide control.
If the cutting tool or deflector becomes
clogged or stuck, always turn off the
engine and make sure the cutting tool
has stopped before cleaning. Grass,
weeds, etc. should be cleaned off the
cutting tool at regular intervals.
!
Warning!
During cutting, check the tightness and
the condition of the cutting tool at regular
intervals. If the behavior of the tool
changes, stop the engine immediately,
and check the nut securing the tool for
tightness and the cutting tool for cracks
and damage. Replace cracked, bent,
warped, damaged or dull cutting tools
immediately. Such tools may shatter at
high speed and cause serious or fatal
injury.
English / USA
!
Warning!
A loose blade may cause the blade to
vibrate, crack, break or come off the
edger, which may result in serious or
fatal injury. Make sure that the blade is
properly tightened. Use the wrench
supplied or one of sufficient length to
obtain the proper torque. If the blade
loosens after being properly tightened,
stop work immediately. The retaining nut
may be worn or damaged and should be
replaced. Never use unauthorized parts
to secure the blade. If the blade
continues to loosen, see your STIHL
dealer. Never use an edger with a loose
blade.
Do not attach any blade to a unit without
proper installation of all required parts.
Never use unauthorized parts to secure
the blade. Failure to use the proper parts
may cause the blade to fly off and
seriously injure the operator or
bystanders.
9