Publicidad
Idiomas disponibles
Idiomas disponibles
TO USE THE RIP FENCE
See Figures 31 and 32.
WARNING:
To reduce the risk of injury, always make sure the rip fence
is parallel to the blade before beginning any operation.
NOTE: The rip fence included with your saw has a low fence.
The low fence should face away from the blade when cut-
ting material greater than 3/4 inches thick. The low fence
should face toward the blade when cutting thin and/or narrow
workpieces. NEVER support the weight of the workpiece on
the low fence while making a cut.
„ Loosen the rip fence by lifting the locking lever.
„ Place the rear lip on the rear of the saw table and pull
slightly toward the front of the unit.
„ Lower the front end of the rip fence onto the guide
surfaces on top of the front rail.
„ Check for smooth gliding action.
„ Position the rip fence the desired distance from the blade.
„ With the rip fence flat on the saw table, push the fence
towards the front rail to align the fence to the blade.
„ Push the locking lever down to align and secure the
fence. When securely locked, the locking lever should
point downward.
NOTE: Ensure the locking lever secures the rip fence
in place. If adjustments are needed, see To Check the
Tightness of the Rip Fence Locking Lever in the Ad-
justment section of this manual.
NOTE: If the rip fence is not parallel to the blade, adjust-
ments are needed. Refer to: To Check the Alignment of
the Rip Fence to the Blade in the Adjustment section
of this manual.
TO SET THE RIP FENCE SCALE INDICATOR
TO THE BLADE
See Figure 33.
Use the indicator on the rip fence to position the fence along
the scale on the front rail.
NOTE: The blade guard must be removed to perform this
adjustment. Reinstall the blade guard when the adjustment
is complete.
Begin with the blade at a zero angle (straight up).
„ Unplug the saw.
„ Loosen the rip fence by lifting the locking lever.
„ Using a framing square, set the rip fence 2 in. from the
blade tip edge.
„ Loosen the screw on the scale indicator and align with
the 2 in. mark as shown.
„ Tighten the screw and check the dimension and the rip
fence.
OPERATION
REAR
LIP
REAR OF
SAW
RIP
FENCE
BLADE
27 - English
RIP
FENCE
RIP
FENCE
SCALE
INDICATOR
MARK
2 in.
LOCKING
LEVER
LOW
FENCE
Fig. 31
LOCKING
LEVER
FRONT
RAIL
Fig. 32
2 in.
SCREW
SCALE
FRONT
RAIL
Fig. 33
Publicidad
