Publicidad
Idiomas disponibles
Idiomas disponibles
MAKING A COMPOUND (BEVEL) MITER CUT
See Figure 47.
WARNING:
Make sure the blade guard assembly is installed and
working properly to avoid possible serious injury.
„ Remove the rip fence.
„ Unlock the bevel locking lever.
„ Adjust the bevel angle to the desired setting.
„ Lock the bevel locking lever.
„ Set the blade to the correct depth for the workpiece.
„ Set the miter gauge to the desired angle and tighten the
lock knob.
„ Make sure the wood is clear of the blade before turning
on the saw.
„ Turn the saw on.
„ Let the blade build up to full speed before moving the
workpiece into the blade.
„ Hold the workpiece firmly with both hands on the miter
gauge and feed the workpiece into the blade.
NOTE: The hand closest to the blade should be placed
on the miter gauge lock knob and the hand farthest from
the blade should be placed on the workpiece.
„ When the cut is made, turn the saw off. Wait for the
blade to come to a complete stop before removing the
workpiece.
OPERATION
35 - English
COMPOUND (BEVEL) MITER CUT
PLACE LEFT HAND ON
MITER GAUGE HERE
Fig. 47
Publicidad
