Publicidad
Idiomas disponibles
Idiomas disponibles
MAKING A MITER CUT
See Figure 43.
WARNING:
Make sure the blade guard assembly is installed and
working properly to avoid possible serious injury.
„ Remove the rip fence.
„ Set the blade to the correct depth for the workpiece.
„ Set the miter gauge to the desired angle and tighten the
lock knob.
„ Make sure the workpiece is clear of the blade before
turning on the saw.
„ Turn the saw on.
„ Let the blade build up to full speed before moving the
workpiece into the blade.
„ Hold the workpiece firmly with both hands on the miter
gauge and feed the workpiece into the blade.
NOTE: The hand closest to the blade should be placed
on the miter gauge lock knob and the hand farthest from
the blade should be placed on the workpiece.
„ When the cut is made, turn the saw off. Wait for the
blade to come to a complete stop before removing the
workpiece.
MAKING A BEVEL CROSS CUT
See Figures 44 - 45.
WARNING:
Make sure the blade guard assembly is installed and
working properly to avoid possible serious injury.
„ Remove the rip fence.
„ Unlock the bevel locking lever.
„ Adjust the bevel angle to the desired setting.
„ Lock the bevel locking lever.
„ Set the blade to the correct depth for the workpiece.
„ Set the miter gauge to 0° and tighten the lock knob.
„ Make sure the workpiece is clear of the blade before
turning on the saw.
„ Turn the saw on.
„ Let the blade build up to full speed before moving the
workpiece into the blade.
„ Hold the workpiece firmly with both hands on the miter
gauge and feed the workpiece into the blade.
NOTE: The hand closest to the blade should be placed
on the miter gauge lock knob and the hand farthest from
the blade should be placed on the workpiece.
„ When the cut is made, turn the saw off. Wait for the
blade to come to a complete stop before removing the
workpiece.
OPERATION
STRAIGHT
VIEWED FROM THE FRONT, BELOW THE TABLE SAW
TO LOOSEN
TO
TIGHTEN
HEIGHT/BEVEL
ADJUSTING
HANDWHEEL
33 - English
MITER CUT
BLADE
LOCKING LEVER
BEVEL CROSS CUT
BLADE
ANGLED
MITER GAUGE
ANGLED
Fig. 43
BEVEL
Fig. 44
MITER GAUGE
STRAIGHT
Fig. 45
Publicidad
