NORAUTO JL-VWB6L Manual De Usuario página 67

Make sure that the switch is off when plugging the tool into the power socket.
„
15. The compressor is only suitable for use in dry rooms. Not for use outdoors
16. Stay alert
Watch what you are doing. Use common sense when working. Do not use the
„
compressor when you are distracted.
17. Check the power tool for possible damage
Before further use of the compressor, carefully check the guards or slightly
„
damaged parts to ensure that they will function properly and as intended.
Check for proper alignment of moving parts, free running of moving parts,
„
breakage of parts, proper mounting of all parts and any other conditions to ensure
proper operation of the power tool.
Damaged guards and parts should be properly repaired or replaced by an
„
authorised service centre, unless otherwise indicated in the instruction manual.
Have defective switches replaced by an authorised service centre.
„
Do not use your compressor if the switch does not turn it on and off.
„
WARNING! The use of other accessories may present a risk of personal
injury.
18. Have your power tool repaired by a qualified electrician
This compressor complies with the relevant safety regulations. Repairs may only
„
be carried out by a qualified electrician using original spare parts. Otherwise,there
is a risk of accidents for the user.
19. Noise
Wear hearing protection when using the compressor.
„
20. Do not touch the hot parts of the compressor
To avoid burns, do not touch the cables, the motor and all other components of the
„
compressor.
Keep the safety instructions for future reference.
INSTALLATION INSTRUCTIONS
Check the tool for transport damage. Report any damage immediately to the
„
transportation company that was used to deliver the compressor.
Install the compressor close to the point of use.
„
Avoid long air lines and supply lines (extension cables).
„
Always make sure that the intake air is dry, dust-free and non-explosive.
„
Do not install the compressor in a damp or wet room.
„
The compressor may only be used in suitable rooms (with good ventilation and an
„
ambient temperature from +5 °C to 40 °C). There must be no dust, acids,vapours,
explosive or inflammable gases in the room.
The compressor is designed for use in dry rooms. It is prohibited to use it in work
„
environments with splashing water.
SAFETY INSTRUCTIONS FOR WORKING WITH COMPRESSED AIR
Compressors and lines reach high temperatures during operation and touching
„
them may lead to burns.
Gases or vapours drawn in by the compressor should be kept free of constituents
„
that may cause fire or explosions inside the compressor.
When you disconnect the hose coupling, hold the coupling element of the hose in
„
your hand to prevent injury from the whipping hose.
EN
65