Publicidad
Idiomas disponibles
Idiomas disponibles
Step 5 :
Tie the brake cable with a Velcro strap, as shown in Picture 8.
Step 6 :
Distinguish the front from the rear before installation, as shown in Picture 9. Align the knee platform with the adjust-
ment tube hole of the walker frame, and lock this positon with one B4 and B2. The installed knee platform should
basically keep level with the
Step 7 :
As shown in Picture 10, put the hooks on the cloth basket through the two holes on the foldable upper rod assembly
and lock
Picture 8
Picture 10
1. Check whether the installation of the knee walker is corrected by referring to the specification drawing for
comparison
2. Verify if all accessories of the walker are fully assembled and if there are unnecessary accessories.
3. Check if the walker is loose or not. If it is loose, tighten the screws and nuts.
4. Chceck all the components of the walker by its appearance to see if there are any skewings, and if any, make
appropriate adjustments.
DMI-F-10_Annexe 2_Notice.13
Version 1.0 27/03/2023
Picture 9
14
Publicidad
