Descargar Imprimir esta página

VDO BVDR 2.0 Manual De Instrucciones Del Usuario página 93

Publicidad

Idiomas disponibles

Idiomas disponibles

2.5.4 Connecting the driver via NFC
With the tachograph turned on, bring the driver ID card close to the NFC
receiver, within 2 cm of the card and the tachograph display. Wait until the
audible alarm sounds and the screen below appears, indicating that the driver
has been identified. Press the button
menu
2.5.5 Connecting the driver via the menu
From the main menu, go to the screen "Driver's Menu", "Connect" and "Driver
List", press
. A list of registered drivers will appear. Simply select the code
and press
to connect.
2.5.6 Disconnect driver via NFC
With the tachograph turned on, bring the driver ID card close to the NFC
receiver, in a horizontal position, so that the card covers the entire display area.
Wait 2 to 4 seconds until you hear the BVDR 2.0 audible alarm indicating that
the driver has been disconnected. Press the
Issue 08/2023
Attention
When bringing the card close to the NFC receiver, make
sure it is in a horizontal position and centered in the
connection region.
Then check that the connection occurs within 2 to 4
seconds.
© Continental Automotive
to advance or wait to return to the
button to confirm.
93

Publicidad

loading

Productos relacionados para VDO BVDR 2.0