Publicidad
Idiomas disponibles
Idiomas disponibles
2.5.12 Integration with telematics device
By integrating a telematics device with the BVDR, it is possible to connect it via
the web to the fleet management solution. The data stored in the BVDR memory
will be transferred remotely without the need for a USB disk.
The data can be viewed as a report on the VDO On Board fleet management
platform. When the BVDR is integrated with the telematics device and together
with the VDO On Board system, the BVDR can send and receive information
from a distance, such as:
Issue 08/2023
BVDR might not recognize some kind of USB disks or
defective USB disks. In case of this occurrence
remove the USB disk, turn Iignition off for 10 seconds,
and then turn the ignition on again. If the issue persists
please change the USB disk to another one in good
use conditions. VDO is not responsible for the
improper functioning of some types of USB disks. The
data stored in USB disk can be viewed as a report
through the VDO On Board platform.
For more information visit: www.fleet.vdo.com.br
Attention
While downloading data, the user must wait for the message
"disk write complete" to appear on the display before removing
the USB flash drive.
Removing the flash drive while recording data can damage it,
causing damage to its file system or possible corruption of the
stored data...
Attention
The memory of the BVDR has corresponding capacity of at
least seven (7) days of vehicle operation counted by the
second, and therefore the oldest data will be overwritten by
the latest data when recording reaches the total storage
capacity. The extraction of data in less than or equal intervals
to seven (7) days to prevent data loss is recommended.
© Continental Automotive
97
Publicidad
