Descargar Imprimir esta página

Sartorius Gold & Carat II Line GL822I-2 Serie Instrucciones De Manejo página 28

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 129
Operation
Procedure
Zero the device. In order to do so, press the [Zero]
t
button.
If a container is being used for the sample:
t
Tare the device. In order to do so, press the [Tare]
t
button.
Place the sample in the container.
t
If no container is used for the sample: Place the
t
sample on the weighing pan.
The weight value is displayed depending on the
y
selected application program.
8.9
Setting or Changing an
Application
Procedure
In the "APPLIC." menu, select an application, e.g.
t
"COUNT.".
Press the [Confirm] button.
t
Exit the menu.
t
8.10 Running Applications
(Examples)
8.10.1 Executing the "Toggle Between Weight
Units" Function
The "Toggle between weight units" function enables a
switch between a maximum of four different units. The
selected basic unit is displayed every time the device is
started (see "UNIT", Chapter "7.3.1 "SETUP"/"BALANCE"
Menu", page 17). The units can be set during the
weighing process and the decimal places can be adjust-
ed. The first convertible unit "Unit 1" is a fixed setting and
cannot be changed. If the base unit is carats then the
first convertible unit will be set to grams; otherwise the
first convertible unit will be carats.
Requirements
The "Toggle between weight units" function is activated
(see Chapter "7.3.9 "APPLIC."/"WEIGH" Menu",
page 23).
The weight value must be valid.
28
Operating Instructions Gold&Carat II Line
Procedure
To switch the displayed weight unit during weighing
t
or before an application: Press the [Toggle between
weight units] button until the desired unit is dis-
played.
The current weight value is displayed in the selected
y
unit.
8.10.2 Selecting Convertible Units and their
Decimal Places
Procedure
Press and hold down the [Toggle between weight
t
units] button.
Select one of the parameters "Unit 2" – "Unit 4" in the
t
submenu. To do so, press the [Confirm] button.
Select the desired unit. To do so, press the [Confirm]
t
button.
Specify the decimal places for the selected unit. To
t
do so, press the [Confirm] button once again.
Select the desired number of display digits. To do so,
t
press the [Confirm] button.
8.10.3 Running the "Density" Application
Use the "Density" application to determine the density
of solid samples using a density set based on the
buoyancy method. The density is determined using Ar-
chimedes' Principle. The upward buoyant force exerted
on a body immersed in a fluid is equal to the weight of
the fluid the body displaces. Positive and negative valu-
es can be stored for weight in air and weight in water.
However, the weight in water must be less than the
weight in air; otherwise, an error message is displayed.
The results can be displayed with 0 to 3 decimal places.
When using 3 decimal places: Using three decimal pla-
ces for density can result in a high measurement error
rate because corrections to the air density and the cal-
culation sets used are not taken into account, for
example.

Publicidad

loading