Publicidad
Idiomas disponibles
Idiomas disponibles
Parameter
Setting values
EXT.CAL.
UNLCKED*
LOCKED
* Factory setting
** Deviating factory setting: Only for models with x= SVN
*** Factory setting for gold and carat only
7.3.2
"SETUP"/"GEN.SERV." Menu
Parameter
Setting values
MENU.RES.
DEFAULT
NO*
* Factory setting
7.3.3
"DEVICE"/"RS232" Menu
Parameter
Setting values
DAT.REC.
XBPI
SBI*
REM.DISP.
BARCODE
YDP20
YDP30
OFF
BAUD
600, 1200, 2400,
4800, 9600*,
19200, 38400,
57600, 115200
PARITY
ODD*
EVEN
NONE
HANDSHK.
SFTWARE
HRDWARE*
NONE
DATABIT
7 BITS
8 BITS*
* Factory setting
Explanation
Activates the external calibration | adjustment function under [CAL./ADJ.].
Deactivates the external calibration | adjustment function under [CAL./ADJ.].
Explanation
Resets the system settings to the factory default settings.
Deactivates the option of resetting the device menu.
Explanations
Extended range of commands to control numerous balance functions with
binary protocol for direct communication with the device.
Enables SBI communication. The data is output to a PC or control unit.
Enables the use of ESC commands from a PC to control the basic balance
functions with ASCII protocol.
Enables data output on another display.
Allows for the connection of an approved barcode scanner.
Sets the standard settings of YDP20 printers.
Sets the standard settings of YDP30 printers.
Deactivates the automatic data output.
Sets the baud rate to the selected value.
Applies an odd parity.
Applies an even parity.
Does not apply a parity.
Sets the handshake protocol to software handshake.
Sets the handshake protocol to hardware handshake.
Does not set a handshake protocol.
Sets the number of data bits to 7.
Sets the number of data bits to 8.
System Settings
Operating Instructions Gold&Carat II Line
19
Publicidad
