Sartorius Gold & Carat II Line GL822I-2 Serie Instrucciones De Manejo página 12

Operating Concept
Symbol Designation
[Invalid weight value]
display
4.4 Menu Structure
4.4.1 "Main Menu" Menu Structure
Navigating in menus (see Chapter 4.5, page 13).
t
Level 1 Level 2
SETUP BALANCE
GEN.SERV.
"General services"
DEVICE RS-232
"RS232, 9-pin"
USB
"USB-C"
EXTRAS
DATA.OUT. COM. SBI
"Data output" "SBI communication"
PRNT.PAR.
"Printout settings"
PC.DIREC.
"Direct transfer of data
(PC)"
APPLIC. WEIGH
"Applications"
COUNT
PERCENT
"Weighing in percent"
ANIMALW.
"Animal weighing"
DENSITY
"Density
determination"
12 Operating Instructions Gold&Carat II Line
Description
— Indicates that the display does not contain a weight value, but is instead
the calculated result of an application, e.g. for the "Animal weighing"
application.
— For conformity-assessed devices: Indicates a fault. The cause of this fault is
displayed after pressing the [Toggle between weight units] key.
Description
Set the functions of the device.
Reset the menu to factory settings.
Define the parameters for the COM interface.
Define the parameters for the USB interface.
Define the functions of the operating display.
Configure the automatic data output.
Perform the settings for the printout.
Define the output format for the data exchange between the
balance and the PC.
— Determine the weight value of a sample.
— Activate the functions for all applications.
Determine the number of parts that have approximately equal
weight.
Determine the percentage share of a sample based on a reference
weight.
Weigh unstable samples, e.g. animals. This program calculates the
average of several measurement cycles.
Determine the density of solid samples based on the buoyancy
method.