Publicidad
Idiomas disponibles
Idiomas disponibles
MANUAL TARE
1.
When weighing an item that must be held in a
container, taring stores the container weight in
memory. Place empty container on the scale
(example 0.5 kg.) and press the TARE button.
Display will show net weight.
2. To clear the tare value, empty the scale and press
the TARE button. The display will show gross weight.
CHANGING UNITS OF MEASURE
Press and hold the PRINT UNITS button until the desired
measuring unit appears.
PRINTING DATA
1.
Printing the displayed data to a printer or sending
data to a computer requires the communication
parameters are set in the print menu.
2. Press the PRINT UNITS button to send the displayed
data to the communication port.
APPLICATION MODES
Only modes enabled in the mode menu are displayed.
WEIGHING
Used to determine weight of items in selected unit of
measure (default factory setting).
1.
Press and hold MODE button until
2. If needed, place an empty container on the pan
and press TARE button to tare.
TO CHECK TARE WEIGHT
1.
Long press TARE button until
t.LJt
is displayed.
2. Tare weight will then be displayed.
3. Add item to pan or container. The weight of the item
will then be displayed.
PARTS COUNTING
Used to count the number of pieces on weighing pan
based on an average piece weight (APW).
1.
Press and hold the MODE button until
COUNT
is displayed.
2. Display will now show
CLEARING A STORED APW
Press YES button and continue to next step.
PAGE 6 OF 35
OPERATION CONTINUED
WEIGH
is displayed.
t.LJt
CLr .PLJ
CLr.PLJ.
RECALL AND USE PREVIOUS APW
Press NO button to begin counting.
NOTE: If display shows
on pan or press TARE button to tare.
3. Display shows default sample size of 10 (
ESTABLISHING A NEW APW
4. To change sample size, short press NO button until
desired value shows on display.
NOTE: Available sample size selections are 2,
10, 20, 50 and 100.
NOTE: When Legal For Trade is turned on,
sample selection 5 will not be available.
5. Place selected quantity of pieces on pan and press
YES button for current table weight.
NOTE: During weighing
process, the display will
show -----.
NOTE: Ensure all pieces in sample are the same
to ensure accurate results.
NOTE: IF APW is betweeen 0.1d and 1d, the
display will show
will then begin count.
NOTE: IF APW is less than 0.1d, the display will
LO.rEF
show
for 1.5 seconds. It will then return
to step three showing sample size. Replace a
heavier batch of samples and press YES button
to re-estableish an APW value.
BEGIN COUNTING
1.
Place parts on pan and read displayed number.
The number of pieces and the PCS icon will be
displayed.
2. Short press FUNCTION button to temporarily display
APW
the APW.
is displayed for one second followed
by APW value with weighing unit.
CHECK
Used to compare the weight of items to a target weight
range.
Display color will change according to the comparing
result.
• Red indicates over target weight range.
• Green indicates within target weight range.
• Yellow indicates under target weight range.
CLr.PAN
, remove weight
PUT. 10
-----
LO.rEF
for 1.5 seconds. Scale
0823 IH-10772
).
Publicidad
