Publicidad
Idiomas disponibles
Idiomas disponibles
ENTER MODE
1.
Press and hold MODE button until
CLr.ACC
2. Display will show
released.
TO CLEAR STORED TOTALIZATION RESULT
Press YES button and begin totalization.
TO RECALL STORED TOTALIZATION RESULT
Press NO button to continue totalization of the last time.
NOTE: If there is weight on the pan, the display
CLr.PAN
will show
TARE button is pressed to tare.
TOTALIZATION METHOD
NOTE: Items must be removed from pan before
next item can be totalized.
NOTE: Only stable weights are stored.
IMPORTANT! When Legal for Trade is turned
on, for NTEP models, gross and net weight
cannot be added to same total. If first weight
is recorded in gross, the future weights should
be recorded the same way. This also applies to
net weight.
MANUAL
Place an item on the pan and press the FUNCTION
button to add the weight to totalization.
AUTO
Place an item on the pan. The displayed value is
totalized automatically.
A flashing
icon indicates the scale has totalized the
weight successfully and will continue to flash until weight
is removed and pan is stable.
VIEW TOTALIZATION RESULTS
With no weight on pan, press the FUNCTION button to
view results.
NOTE: Results are displayed for one second
each.
TOTALIZATION RULES
Totalization operation will fail when:
• Current weight is unstable.
• Load's net weight is smaller than 5d.
• Overall totalized number is larger than 999,999.
• Total number of totalization exceeds 9,999 times.
PAGE 8 OF 35
OPERATION CONTINUED
tOtAL
is displayed.
when MODE button is
until weight is removed or
LEGAL FOR TRADE
When the indicator is used in trade or a legally
controlled application, it must be set up, verified and
sealed in accordance with local weights and measures
regulations. It is the responsibility of the purchaser to
ensure that all pertinent legal requirements are met.
SETTINGS
Before verification and sealing, perform the following steps:
1. Verify that the menu settings meet the local weights
and measures regulations.
2. Perform a calibration. (See pages 4-5)
3. Turn indicator off.
TURNING SECURITY SWITCH ON
1.
Disconnect power from indicator and open the
housing.
2. Turn security switch to ON. (See Figure 5)
Figure 5
3. Close housing, reconnect power and turn indicator
on.
ON OFF
0823 IH-10772
Publicidad
