Publicidad
Idiomas disponibles
Idiomas disponibles
SET CHECK LIMITS
1.
Press and hold MODE button until
displayed.
CLr.CHK.
2. Display will show
USE EXISTING UNDER/OVER VALUE.
Press NO. Scale will then enter check mode directly.
TO SET NEW OVER/UNDER VALUES
Press YES button and continue to next step.
3. The display shows under. Press YES button to edit the
under value.
000000
4.
will flash on the display until number is set.
5. Short press the NO button until desired number
appears.
NOTE: Press BACK button to decrease digit.
NOTE: If negative value is necessary, press
BACK button and continue to next step.
6. Short press YES button to accept number and move
to next digit.
7.
Repeat steps 3-6 for over values.
8. If set values are invalid, display
--NO--
will show
and return to reset
under/over value. If values are valid,
scale will enter check mode.
NOTE: Short press FUNCTION button to display
the current under/over value.
POSITIVE CHECK
Used to determine when material added to scale is
within target weight range. Under/over values must be
postive and over value must be greater than under to
achieve accurate result.
1. Add material to pan until display turns green.
NEGATIVE CHECK
Used to determing when material removed from scale
is within target weight range. Under/over values must be
negative and under value must be larger than over to
achieve accurate result. (Example: Under value is -10;
over value is -15)
1.
Place package or bin of material on scale and
press TARE button.
PAGE 7 OF 35
OPERATION CONTINUED
CHECK
is
CLr .CHK
--NO--
2. Remove a portion of the package or material until
display turns green.
NOTE: To continue weighing multiple portions
off the scale's pan, tare the scale between
each portion.
ZERO CHECK
Used when comparing subsequent samples to an initial
reference sample. Under value must be zero
or negatvie. Over value must be zero or positive.
1.
Place reference sample on scale and press TARE
button.
2. Remove material from scale until display turns green.
TOTALIZATION
Used to manually or automatically accumulate multiple
weights. Statistical data (number of samples, total
weight, average weight, minimum/maximum weight and
difference in weight) is stored in memory for review and
printing.
FUNCTIONS
Off
OFF (
) – Disable the totalization function.
MANU
Manual (
) – Press FUNCTION button to perform
totalization manually.
NOTE: Manual is set as default totalization
function.
AUtO
Auto (
) – Scale will perform totalization
automatically.
SETTING TOTALIZATION OPTION
1.
Long press MENU button until
C.A.L
display.
will show on display when MENU
button is released.
2. Short press NO button until
display. Press YES button.
3. Short press NO button until
display. Press YES button.
4. Short press NO button to cycle through totalization
options. Press YES to confirm selection.
5. Press EXIT button to exit.
MENU
appears on
MODE
appears on
tOtAL
appears on
0823 IH-10772
Publicidad
