Remote Control - Corghi EXACT 70 II Manual De Uso

A key LED does not light up
Burned LED or key not making the necessary
contact
➥ Keep pressing the defective key and if the
defect is not eliminated, contact the after-sales
service.
Sensor does not perform ROC
Transducer values are fluctuating too violently
➥ Make sure that the vehicle is stably positioned
and wait.
ROC key pressed too quickly
➥ Switch the wheel aligner off then repeat the
compensation operations slowly; if the defect
does not appear, skip compensation (ROC 0)
and call the after-sales service.
Data transmission defective or beam obstructed
➥ Remove the obstacle which is obstructing the
measuring beam and/or level the sensors.
Steering wheels not straight
Compensation routine performed incorrectly
➥ Repeat compensation taking care that the
corresponding wheel on the opposite side
of the vehicle does not rotate or steer (in the
case of steer wheels).
Sensors not calibrated
➥ Calibrate the sensors.
CALIBRATION
Data on red background persist
with sensors fitted on calibrator,
connected correctly and levelled
Something is obstructing the passage of the
infrared beam between the goniometers
➥ Remove the obstruction.
One or more transducers out of tolerance range
➥ Call the service centre and do not use the
wheel aligner.

REMOTE CONTROL

Program does not change when
keys are pressed
Battery flat
➥ Replace the battery.
Distance between remote control and central
unit too great
➥ Move closer: max distance 6m.
Remote control pointing in wrong direction
86
➥ Point the remote control towards the eye of
the receiver.
➥ Hold the remote control properly.
Too much ambient light
➥ Move closer.
PRINTER
Does not switch on
Printer switch "OFF"
➥ Turn the printer switch to "ON".
No power
➥ Check that the printer plug is connected cor-
rectly.
Switches on but does not print
Cable crushed between steel plate parts
➥ Position the cable correctly.
Printer in standby status, "on line" LED off
➥ Press the "ON LINE" button to illuminate the
LED.
Does not print properly
Print head failure
➥ Call the service centre.
Printing too pale
Ink ribbon worn out or broken
➥ Change the cartridge, following the instructions
in the printer manual.
"ERROR" LED on - "ERROR" LED
flashing
No paper
➥ Fit fresh sheets of paper, following the instruc-
tions in the printer manual.
WARNING
the "Spare Parts" manual does not authorise
the user to do any work on the machine except
for that specifically described in the operator's
manual, but does enable the user to provide
accurate information to the after-sales service,
in order to reduce service times.
Operator's Manual EXACT 70 II