Enabling Extra Wheel Aligner Functions; Installation Space - Corghi EXACT 70 II Manual De Uso

STD ...") with that stated on the installation CD-
ROM supplied with the aligner.
If the CD-ROM release is more recent than the
release installed, update the aligner software.
Detailed information about the software update
procedure is provided in the leaflet accompany-
ing the CD-ROM.
Enabling extra wheel aligner
functions
Extra wheel aligner functions are enabled by
upgrading the main protection SIM CARD (identi-
fied with the symbol
Upgrading is performed with the "Upgrade
SIM CARD" obtained by ordering the relative
accessory kit.
Upgrade cards carry specific identification
symbols; detailed information on upgrade
identification is supplied in the leaflets which
accompany them.
To upgrade the main protection card, run the
relative procedure with the icons
and and follow the on-screen
prompts. You will be asked to remove the main
Hard Lock SIM CARD and insert the upgrade SIM
CARD. After the procedure, the main SIM CARD
must be reinserted.
The upgrade SIM CARD cannot be reused. How-
ever, keep it for use if it becomes necessary to
reprogram the main card of the wheel aligner for
which it was used the first time.
The , and
the system configuration:
CARD: card number 1 is the wheel aligner's main
card; card number 2 (if any) is an upgrade card.
HEADER: "MAS" aligner main card, "AGG" up-
grade card.
SERIAL: card serial number. For main cards
this number is unique. For upgrade cards the
number is 0 when they are new, while after use
it becomes the same as that of the main card
that has been upgraded.
DATE: card creation date.
VAS: "ON" VW/AUDI program on, "OFF" pro-
Operator's Manual EXACT 70 II
gram off.
MLK: "ON" MULTILINK suspension car program
on, "OFF" program off.
REN: "ON" RENAULT program on, "OFF" program
off The RENAULT program reverses the toe signs
for RENAULT vehicles only.
MER: "ON" MERCEDES program on, "OFF"
program off.
PHEATON: "ON" VW Phaeton and Touareg pro-
gram on, "OFF" program off.
ANIM: "ALL" display of alignment adjustment
help animations on, "FIN" display of non-moving
alignment adjustment help diagrams, "OFF"
).
alignment adjustment help graphics off.
TRUCK:"ON" truck/trailer program on, "OFF"
program off.
ROMESS: "ON" ROMESS CM-09606 inclinom-
eter automatic connection program on, "OFF"
program off.
ASANTW: "ON" ASA Network program on, "OFF"
program off.
RADAR: "ON" vehicle anti-collision radar calibra-
tion program on, "OFF" program off.
,
CUSTOM: type of wheel aligner customisation.
BD YEAR: year of the latest databank upgrade, if
"DEMO" the aligner card has not been inserted
or is not functioning correctly.
The installation site must be chosen in compli-
ance with local regulations regarding safety in
the workplace.
icons display
The floor must be able to withstand a load
equal to the sum of the weight of the equipment
itself and the maximum payload, bearing in
mind the lift support surface area and anchor
fixtures used.
Place the aligner in the designated work position
and make sure that the rear panel of the equip-
ment is at least 10cm away from the nearest wall.
IMPORTANT: for correct, safe use of the equip-
ment, users must ensure a lighting level of at
least 300 lux in the place of use.

Installation space

WARNING
EN
51