cecotec DRUMFIT X-BIKE 3000 NEO Manual De Instrucciones página 50

ENGLISH
4. OPERATION
Adjusting the saddle height
When adjusting the saddle height, bear in mind that the correct position should be one in
-
which your hip is not tilted to one side when the pedal is in its lowest position and your foot
is fully inserted and engaged in the toe clip. Fig. 8
The saddle height can be adjusted by removing the adjustment knob and raising or
-
lowering the saddle. Once the correct height has been chosen, refit the adjustment knob
and tighten it. Adjust the saddle height between the first and last hole of the saddle post.
Do not adjust the saddle during exercise. Fig. 9
Fig. 9 key:
1. Unscrew the height adjustment knob.
2. Adjust the saddle to the desired height.
3. Retighten the height adjustment knob.
Resistance control
The resistance knob allows to adjust pedalling resistance. A high resistance makes it more
difficult to pedal, while a low resistance makes it easier. For better results, set adjust the
resistance during use. Fig. 9
Getting on and off the exercise bike
To get on the exercise bike, first make sure that the latter is completely still. Stand next to
-
the exercise bike and pass the leg that is closer to it over the frame to sit on the saddle,
then insert your feet in the pedal toe clips.
To get off the exercise bike, do the previous step in reverse order.
-
Note
If the display doesn't show any value, make sure the control panel is properly connected. If the
problem persists, replace the batteries.
LCD display
Function button
Reset: hold down the function button for over 3 seconds to reset all values, except the
Odometer.
Functions
SCAN: press this button until the display shows 'SCAN'. The LCD display will automatically
-
alternate between TIME, SPEED, DISTANCE, CALORIES, and ODOMETER.
TIME: press this button until the display shows 'TIME'. The LCD display will count up your
-
workout time.
50 DRUMFIT X-BIKE 3000 NEO