Kärcher HD 1.8/13 C Ed Manual De Instrucciones página 11

Risk of injury! The trigger and safety le-
ver may not be locked during the oper-
ation.
Risk of injury! Contact Customer Ser-
vice if the safety lever is damaged.
Risk of injury from high-pressure water
jet. Slide the safety catch on the trigger
gun forward before performing any
work with the appliance.
CAUTION
Clean engines only at places with cor-
responding oil separators (environ-
mental safety).
Opening/closing the trigger gun
To open the trigger gun: Actuate the

safety lever and trigger.
To close the hand spray gun: Re-

lease the safety lever and trigger.
High pressure operation
The appliance can be operated in a
vertical or horizontal position.
Note:
The appliance is equipped with a pres-
sure switch. The motor starts up only
when the trigger gun is open.
Set the appliance switch to "I".

Release the trigger gun. To do so,

push the safety catch towards the
back.
Open the hand spray gun.

Select spray type
Close the hand spray gun.

Turn the casing of the nozzle till the

desired symbol matches the mark-
ing.
High pressure circular
spray (0°) for specially
stubborn dirt
Flat low pressure spray
(CHEM) for operating using
detergents or cleaning at
low pressure.
High pressure flat spray
(25°) for large dirt areas
Operation with detergent
WARNING
Unsuitable detergents can cause dam-
age to the appliance and to the object
to be cleaned. Use only those deter-
gents that have been approved by
Kärcher. Observe the dosage and oth-
er instructions provided with these de-
tergents. For considerate treatment of
the environment use detergent eco-
nomically.
Follow the safety instructions for using
detergents.
Kärcher detergents ensure smooth
functioning. Please consult us or ask
for our catalogue or our detergent in-
formation sheets.
Take out detergent suck hose.

Adjust the suction volume of the de-

tergent solution at the detergent fil-
ter.
Suspend end of suction hose in a

container filled with detergent.
Set nozzle to "CHEM".

Recommended cleaning method
Spray the detergent sparingly on

the dry surface and allow it to react,
but not to dry.
Spray off loosened dirt with the

high-pressure ray.
Set the suction flow on the deter-

gent filter to the maximum quantity
after operation.
Start the appliance and rinse for

one minute.
– 8
EN 11