Kärcher HD 1040 B Cage Manual De Uso página 19

Dispose of old oil ecologically or turn it in
at a collection point.
 Screw in the oil drain screw.
 Fill in new oil slowly until the centre of
the oil level display.
Note
Air pockets must be able to leak out.
For oil type refer to technical specifica-
tions.
Motor
Carry out maintenance tasks to the engine
according to the specifications provided in
the operating instructions of the engine
manufacturer.
High pressure hose
Danger
Risk of injury!
 Check the high pressure hose for dam-
ages (risk of bursting).
Please arrange for the immediate ex-
change of a damaged high-pressure hose.
Frost protection
Warning
Risk of damage! Freezing water in the ap-
pliance can destroy parts of the appliance.
Store the appliance in a heated room dur-
ing winter or empty it. During longer breaks
in operation, it is advisable to pump in anti-
frost agents into the appliance.
Drain water
 Screw off water supply hose and high
pressure hose.
 Operate device for max. 1 minute until
the pump and conduits are empty.
Flush device with anti-freeze agent
Note
Observe handling instructions of the anti-
freeze agent manufacturer.
 Pump in conventional frost protection
agents through the appliance.
A certain corrosion protection is achieved
with this as well.
All manuals and user guides at all-guides.com
EN
Faults
Danger
Risk of injury if the machine is left running
in an unattended state. Remove the spark
plug before doing any work on the appli-
ance.
Risk of burns! Do not touch hot silencers,
cylinders or radiator ribs.
Appliance is not running
Follow operating instructions of the engine
manufacturer!
Safety thermostat at the high pressure
–
pump has switched off the appliance af-
ter long period of cycle operation.
 Allow the appliance to cool down; then
restart it. Refer section "Interrupting op-
eration".
Device is not building up pressure
Operating speed of the engine is too
–
low
 Check operating speed of the engine
(refer to technical data).
Nozzle is set to "CHEM"
–
 Set nozzle to "High pressure".
Nozzle is blocked/ washed out
–
 Clean/ replace nozzle.
Sieve in the water connection is dirty
–
 Clean sieve.
Air within the system
–
 Appliance ventilation:
Amount of water supply is too low.
–
 Check water supply level (refer to tech-
nical data).
Pipe inlets to pump are leaky or blocked
–
 Check all inlet pipes to the pump.
Device leaks, water drips from the
bottom of the device
Pump leaky
–
Note
3 drops/minute are allowed.
 With stronger leak, have device
checked by customer service.
– 7
19