Promax PROLINK-4 Manual De Instrucciones página 176

4.9.4.1 Selection of the RF Band: (Band switching)
Permits to switch from terrestrial (5-862 MHz) to satellite band (900-2150 MHz)
and viceversa.
4.9.4.2 Selection of the TV System and Standard (System & Standard)
This function enables the television system and standard to be changed. The
standards which can be selected depend on the band in use (terrestrial or satellite
channels). To change the standard access the TV mode functions menu, then turn the
rotary selector [4] to the System & Standard function and press the rotary selector
again [4]. A fold down menu will appear listing the following options:
Terrestrial bands
PAL-B/G
PAL-D/K
PAL-I
PAL-M
PAL-N
SECAM-B/G
SECAM-L
SECAM-D/K
NTSC-M
Digital (PAL)
Turn the rotary selector [4] to the desired standard and press to activate it.
If a digital channel is selected, whether terrestrial or satellite, for the
measurement of the level and the carrier-to-noise ratio to be correct, the bandwidth of
the channel must be defined, using the Channel BW function of the functions menu.
In order to change the standard of the digital signals previously you must select
the corresponding analogue standard.
The following table shows the features of the analogue terrestrial channel
standards.
Lines/
System
frame
B 625/50
D 625/50
G 625/50
H 625/50
Page 58
Channel Video/sound
Bandwidth separation
7 MHz
8
8
8
USER'S MANUAL. PROLINK-4
Satellite band
PAL
SECAM
NTSC
Digital (PAL)
Video
Mode
5.5 MHz Neg
6.5 Neg
5.5 Neg
5.5 Neg
Audio
Mode
FM
FM
FM
FM
02/2003